Quicklogic Forums

Is anyone aware of low power example applicatio/guide for quick feather board ?
Or
How do I configure it into low power mode ? As in , is it something to do with the configuration macros (example ENABLE_LPSD macro) defined in the Fw_global_config.h file ?

I did go through the low power data sheet [/https://www.quicklogic.com/wp-content/u ... t-2020.pdf] available on the website, it gave me insights of hardware configuration , however how do I leverage it on the firmware side. ?

Has been over two weeks, still no reasonable response. !

You might check https://qorc-sdk.readthedocs.io/en/late ... power.html

Never Knew that I could bump into Spammers on a techinal forum as well.