Simple streaming QFB data to SensiML DCL

Post Reply
timothym
Posts: 9
Joined: Mon Mar 08, 2021 3:53 pm

Hi

I am using example binary file quickfeather-simple-stream-data-collection.bin from following link:
https://sensiml.com/documentation/firmw ... ather.html

I want to know that does this example firmware require USB to TTL serial adapter?

is following adapter compitable?
https://robu.in/product/ft232rl-usb-to- ... r-arduino/

FT232 has following pins

FTDI ------ QFB
GND —-> GND
VCC —-> VCC
TX —–> Pin 2
RX —-> Pin 3
DTR —-> ?

where should I connect DTR?

Thanks
ale@quicklogic.com
Posts: 3
Joined: Wed Jun 03, 2020 4:47 am

QuickFeather UART supports RX and TX only. There is no support for Control signals.
Post Reply