A very silly question.
The Adapter QD-PL6884 on the Dek Fab Prommer should be OK to programm The PASIC1 but:
How the PASIC1 (QL8x12B-0PL68C) have to be placed in the Adapter of the DEskfab Prommer.
Pin 1 of the QL8x12B-oPL68C the is in the center of the chip. The Pin 1 mark on the Adapter is at the edge.
The more, in the old Promer QP-84 P I found a doc where the chip has to be placed upside down in the Adapter.
I just have few of the chip ANd I donw want to try evere possible placement.
Someone oas a dok which shows how the PASIC1 have to be placed in the QD-PL6884 Adapter of the prommer
THanks
RAlph